Super-high Pressure Multiport Assembly
The Multiport type water level gage becomes ( the following figure reference ) mainstream from the past as the water level gage for the hot high pressure boiler but as for most, a glass part is tentatively intended in the improvement of the damaging prevention and the airtightness of gage glass by the floating formula mechanism. However, it is a state which it isn't possible to say that the airtight maintenance period satisfies the desire of the users shortly by the temperature cycle under being continuous and also the high temperature and so on about glass damaging danger to to be used under the hot high pressure.
We swept danger, the scatter of glass, by the development of KLINPORT KP-32, 34 types and the extension improvement in the airtight maintenance period could be realized.
The comparison between the conventional Multiport type water level gage ( the floating type ) and the KLINPORT use type water level gage
In case of the conventional water level gage
- When the crack occurs to glass, there is scattering danger.
- There is necessity of Hot Bolting.
- The temperature change and the degradation of the gasket and so on cause the relaxation of the seal part. Then, there is possibility to leak out.
- There is fear which damages glass in case of repair and so on. It isn't possible to be generally re-applied by it.
- There are many numbers of the parts and the construction at the glass port is difficult. The maintenance is bad.
- Gauge body
- Tight-Packing
- Steel foil
- Mica
- Mica
- Side-Packing
- Gauge glass
- Cushion-Packing
- Carbon sheet
- Gauge Cober
- Bolts
In case of the conventional water level gage
In case of the KLINPORT water level gage
- There are few pressure-resistant extreme declines even if the crack occurs to glass. It is difficult to scatter.
- Because it is using Spring cone, there is not relaxation of the seal part. It is difficult to leak out.
- Because there is not fear which damages a glass part in the KLINPORT KP-32 type, it is usable once again.
- The simple structure becomes possible in using KLINPORT and makes to make a number of parts a small number and the simplification of the construction it possible. It is very excellent about the maintenance.
- Gauge Body
- Sheet-Packing
- Mica Plate
(Two pieces or three pieces)
- KLINPORT
(KP-32)
- Plain Washer
- Spring cone
- Gauge Cover
- Bolts
KLINPORT(KP-32) Water Level Gauge port Assembly